Close

Login

Logging In
Invalid username or password.
Incorrect Login. Please try again.

not a member?

Signing up could earn you gear and it helps to keep offensive content off of our site.

March 05, 2008

SeaSucker Rod Holder

The 9-inch, custom-designed polished-stainless holder was built to work with the 4 1/2-inch SeaSucker vacuum cup.
by Chris Woodward
Related Tags: Fishing Tackle
print
Comment
03gr seasuckerholder300
Enlarge Photo

Related Gear

On the heels of its stainless three-rod holder, SeaSucker introduces a single rod holder rated to hold against 120 pounds of pull. The 9-inch, custom-designed polished-stainless holder was built to work with the 4 1/2-inch SeaSucker vacuum cup. The holder's two support feet - above and below the cup - provide sheer holding (as opposed to pull) power and torque resistance. The feet come with plastic caps to prevent scratching the gelcoat; the holder - at 1 3/4 inches in diameter - features a gimbal pin and a foam insert to shield the rod butt. Retail price is $89.99. Call 941-586-2664 or visit www.seasucker.com.

post a comment
  • Anonymous comments will appear after it has been approved by a moderator.
  • Login or Register Now for your comment to appear immediately.
Please note: your comment will appear after it has been approved by a moderator. If you login or register your comment will appear immediately
The content of this field is kept private and will not be shown publicly.
All submitted comments are subject to the license terms set forth in our Privacy Policy and Terms of Use